KLING & FREITAG K&F CA 1515-9 - SP - Manual (Page 27)

User’s Manual ‘SP’ Models based upon the CA Series
KLING & FREITAG GMBH ©2003 - 2014 Version 7.1, 09.09.2014 Page 27 of 52
13.2 CA 1201 - SP
Loudspeaker
Design 2-way full-range system with integrated driver
and power amplifier technology, bass reflex tuning
Frequency range -10 dB 54 Hz - 19 kHz ('FILTERS OFF')
Frequency range ±3 dB 65 Hz - 18 kHz ('FILTERS ON' and 'FILTERS OFF')
Nominal coverage angle 90° x 60° (hor. x vert.) / rotatable horn
Directivity index (DI) 10 (+1.5/-1) 1.2 kHz - 16 kHz
Max. SPL 126 dB (SPL peak/1 m)
Components 12" low-mid chassis
1“ high freq. driver with 40 mm Mylar dome on
rotatable 90° x 60° CD horn
Crossover passive, 1.8 kHz 18 dB/octave, self-resetting protection
circuits for 12" and 1" chassis
Supply voltage 230 V version: AC 195-250 V, 50 / 60 Hz
alternative 115 V version: AC 95-125 V, 50 / 60 Hz
Power consumption nominal @ 230 V: 1.25 A @ 115 V: 2.5 A
Power consumpt. max (Irms / <500 ms) @ 230 V: 7 A @ 115 V: 14 A
Idle current @ 230 V: 200mA @ 115 V: 400 mA
Power connectors Neutrik PowerCon, lockable, 1 input and 1 output
Input module
Signal connectors Pin 1 = ground / pin 2 = + signal / pin 3 = - signal
LINE IN: XLR 3 pin female
LINE OUT: XLR 3 pin male, parallel with LINE IN
Input sensitivity +6 dB / 1.55 Vrms for rated output
Input impedance 50 kΩ (balanced / unbalanced)
Common mode rejection Min.: 74 dB, typical: 90 dB
Controls Level control ± 6 dB, by-pass switch for the
active filters (for operations with i.e. K&F Controller),
ground lift switch
Display Bi-coloured LED: green = Power On,
red = Limit / Protect
Driver circuit High pass 45 Hz (-3 dB), 24 dB / octave (‘FILTERS ON’),
Phase correction, frequency equalisation (EQ)
peak limiter, RMS limiter
Amplifier module
Type Class D
Power 1000 W @ 8 Ω ( EIAJ / 1 kHz, 1% THD)
Power bandwidth 10 Hz to 30 kHz
Damping factor > 500 (100 Hz), > 100 (10 kHz)
S / N ratio > 105 dB (A)
Cooling Air convection (without fan)
Protection circuits Short circuit, over-temperature, clipping, overload
Enclosure
Trapezoidal with additional cluster angles,
15 mm birch plywood with highly resistant
grey or black structured paint,
2 butterfly handles, mounting flange K&M 19656,
ball proof front grille with exchangeable,
black acoustic foam
Rigging 5 flying points ‘allsafe JUNGFALK’
Dimensions 380 x 605 x 375 mm (W x H x D)
Weight 27.5 kg
Options Rigging and mounting hardware,
special finish in RAL colours
Technical changes without prior notice reserved