Caution – KLING & FREITAG K&F CA 1515-9 - SP User Manual

Page 6

Advertising
background image

User's Manual

‘SP’ Models based upon the CA Series

KLING & FREITAG GMBH ©2003 - 2014

Version 7.1, 09.09.2014

Page 6 of 52

1. General Safety Instructions

Warning: To avoid electric shock hazard, do not expose this

appliance to rain or moisture. The enclosures may only be

opened by qualified personnel!

Do not install devices in any of the following places:

− where the devices are permanently exposed to direct sunlight.
− near any heat sources and open fire. Do not put candles etc. on top of the speaker.
− where the airflow for cooling is blocked. A minimum distance of 10 cm to the heat

sink on the rear of the speaker must be kept.

− where the devices are exposed to high moisture. Objects filled with liquids, such as

a vase, must not be placed on the speaker.

− where the devices are exposed to strong vibrations and dust.

Power supply

Before connecting the AC power cable of the SP speaker, please check if the available
voltage is compatible with the operating voltage as indicated on the unit. If this is not
the case, then the unit needs to be adapted by the manufacturer or an authorized ser-
vice centre. If the unit is not compatible with the available voltage, it should never be
connected! This could irreparably ruin the SP speaker.
Make sure that the power outlet supplies a ground connector, which must be con-
nected to the unit via the PE conductor of the power cord!
All equipment, which is connected together using signal cables and has a connection to
protect ground, must be connected to a common PE conductor. If not, there is a risk of
an electric shock or the destruction of the connected equipment.
The power plug must always be used to disconnect from the power supply. Further-
more, the power plug must be easily accessible for use at all times.

Protection of electrical cables

Power cords should be laid in such a way that they are protected against footstep dam-
ages, tensile strain and against being trapped.

Transportation

When transporting the equipment, make sure that it is protected from vibrations.

Cleaning

The equipment should only be cleaned with a damp cloth when it is not plugged in.

Pauses in use

The power cord should be disconnected from the power source during longer pauses
in use.

Intrusion of objects or liquids

No objects or liquids should intrude or leak into the equipment.

Warning

Risk of electric shock!

Do not open the units!

CAUTION

Advertising
This manual is related to the following products: