Paxton Superchargers Dodge SRT-10 Ram User Manual
Page 10
1-2
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2))
H.
Lift up on the lower portion of the air filter
enclosure removing it from the rubber grom-
mets that secure the back portion of the air
filter enclosure. Once removed from the
vehicle, set the enclosure aside. It will not
be reused.
I.
Remove the crank case breather hose located
under the throttle body and set aside to be
modified and reinstalled in a later step.
*** NOTE ***
2005 6-speed and Quad Cab trucks may be different.
J.
Remove the four 13mm headed bolts that
secure the top portion of the extra battery
box and set aside as they will not be reused.
(See Fig. 1-f for location.)
K.
Remove the 10mm bolt that secures the
heater hoses to the battery box. (See Fig.
1-f.)
L.
Remove the passenger’s side front tire and
remove the 8mm headed screw that retains
the inner fender liner. Remove the liner and
set aside to be reinstalled in a later step.
M.
Locate the two bolts that secure the battery
box from inside the fender well. Remove
and set aside. (See Fig. 1-f.)
*** NOTE ***
Two of the 8mm headed bolts that secure the inner
fender liner will not be reinstalled. Their location was in
the bottom of the battery cover.
S.
Reinstall the factory oil cooler in its original
location using the factory hardware.
F.
Remove the idle air control hose from the
IAC. Set the hose aside as it will not be
reused.
G.
Remove the one 10mm nut located at the
front of the lower air box enclosure. (See
Fig. 1-e.)
Fig. 1-e
Fig. 1-f
10mm NUT
INNER FENDER
FRAME-REAR
10mm HEADED
BOLT
13mm HEADED
BOLTS
N.
From inside the engine compartment,
remove the battery box and set aside. It will
not be reused.
O.
In preparation for removing the plastic air
deflector shield that attaches to the inner
fender, remove the two 13mm headed bolts
securing the engine oil cooler in place. Set
the cooler aside to be reinstalled in a later
step.
P.
Remove the plastic clips that retain the plas-
tic air deflector. (See Fig. 1-g.)
Q.
Remove the deflector and set aside, it will
not be reused.
R.
Reinstall the inner fender liner in the reverse
order removed. Reinstall the passenger’s
side tire.
Fig. 1-g