Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 18)

4-2
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2))
J. With the supercharger mounting plate, spac-
ers and bolts installed, start tightening the
1/2" headed bolt going into the front cover
of the engine. Next tighten the lower alter-
nator through-bolt and then the upper alter-
nator bolt.
K. Reinstall the factory idler pulley using the
stud spacer provided in place of the factory
retaining bolt. (See Fig. 4-e.)
*** NOTE ***
The photo shows the Factory fastener for reference
and will not be reused. (See Fig. 4-e.)
L. Locate the three supplied accessory idler pul-
leys with their proper spacers and two 3/8" x
16 x 1.75" bolts and washers. Install the
smooth 90mm idler at the 3/8"-16 tapped hole
location next to the alternator. Install the plas-
tic 7-rib grooved idler just above the smooth
idler using the provided fasteners. (See Fig.
4-f.) See assembly drawing 4PCS111-044 in
Appendix A for these locations.
*** NOTE ***
In Fig. 4-f, the upper A/C line will have to be removed
from its original location to gain clearance for the S/C
mounting plate.
Fig. 4-d
Fig. 4-e
Fig. 4-f
M. Locate the supercharger support plate with
the seven 1.543" x .390" x Ø.750" spacers
and its mounting hardware.
N. Install the support plate over the stud bolt
that was installed in the factory idler loca-
tion using the 3/8" –16 nyloc nut and washer
leave these fasteners loose until all of the
spacers and bolts are installed.
O. Please check the mounting hardware against
the bill of materials in the front of the manu-
al for the lengths and quantities.
P. Install the 6-1.543" long spacer between the
supercharger support plate and the super-
charger mounting plate with the bolts pro-
vided.
Q. There are three bolts that are 2.5" in length.
One will be located just above the alternator
and the other two are installed between the
supercharger mounting holes and the alter-
nator.
SPACER
FACTORY SCREW
(DO NOT RE-USE)
I. Locate the .335" x 1.0" x .484" spacer and
the 3/8" x 16 x 2.75" bolt and 3/8"AN flat
washer. Install the spacer and the bolt in the
upper alternator mounting location. (See
Fig. 4-d.)
*** NOTE ***
The spacer goes between the supercharger mounting
plate and the alternator. (See Fig. 4-d.)