Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 26)

7-2
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2))
7.3 WATER PUMP INSTALLATION
A. Locate the water pump assembly. The water
pump will be attached to the triangular
shaped water tank supplied in the kit.
B. Install the two 90º x 1/2"NPT x 3/4" fittings
into the heat exchanger using teflon paste on
the threads. These fittings, when installed,
should face the passenger’s side of the vehi-
cle.
C. Attach the heat exchanger to the front of the
air conditioning condenser mounting brack-
ets using the fasteners that are provided.
(See Figs. 7–e, 7-f.)
Fig. 7-e
B. Attach the water pump to the reservoir using
one 1-1/8" insulated clamp and a 1/4-20 x
1/2" socket head bolt and one 1/4"AN wash-
er. (See Fig. 7-g.)
J. You will need to mark/drill in the brackets
that are in front of A.C.. Use the 1/4-20
bolts/nylock.
C. Attach the Ø3/4" x 4 x 12" “L” shaped hose
to the 1/2"NPT x 3/4" x 90º barbed fitting
located at the bottom of the triangle water
reservoir (NOTE the 90º hose attached to
the water pump and the fitting at the bottom
of the water tank will need to be trimmed to
fit) and secure with the provided nylon
clamps. (See Figs. 7-f, 7-g.)
*** NOTE ***
The angled bracket that is attached to the water tank is
in place just to show its orientation to the water pump.
This bracket will be installed in a later step of the
installation.
Fig. 7-g
Fig. 7-f
*** NOTE ***
After the installation of the hoses from the heat
exchanger to the CAC and the water reservoir, the air
deflectors on the hood will need to be trimmed for
clearance.
7.2 WATER COOLER ASSEMBLY
INSTALLATION.
A. Attach the right and the left heat exchanger
bracket to the heat exchanger using the 1/4-
20 x 1-1/4" bolts, nuts and washers provided
in the heat exchanger assembly.