Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 29)

8-1
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
Fig. 8-a
Section 8
ENGINE CONTROL UNIT ASSEMBLY
G. Install one 5/32" vacuum TEE in the vacu-
um hose coming out of the Paxton ECU
attach the hose coming from the 3/8" x 3/8"
x 1/4" fitting installed earlier.
H. Install a piece of 5/32" hose to the compres-
sor bypass valve and secure to the vacuum
TEE installed in the Paxton ECU in an earli-
er step. (See Fig. 8-d.)
8.1 ENGINE CONTROL UNIT
ASSEMBLY
A. Locate the engine control assembly
5A001-077. (See Appendix A-4 for refer-
ence.) It is recommended that you refer to a
factory manual to confirm wire colors and
pin locations.
B. Attach the Paxton ECU to the passenger side
inner frame rail in the engine compartment
using the fasteners that are provided. (See
Fig. 8-a.)
Fig. 8-b
Fig. 8-c
C. Install the 3/8" x 3/8" x 1/4" brass vacuum
TEE with a short piece of 3/8" EFI fuel hose
between the brake master cylinder and the
vacuum source from the intake manifold.
(See Fig. 8-b.)
D. Attach a length of 5/32" vacuum hose to the
1/4" outlet of the vacuum TEE and one
5/32" vacuum TEE.
E. Attach a length of 5/32" vacuum hose to the
5/32" vacuum TEE and route down the inner
fender well and secure with nylon ties this
vacuum hose will be attach to the FMU in a
later step.
F. At the other end of the vacuum TEE, attach
a length of hose and route through the facto-
ry wire loom running across the firewall.
(See Fig. 8-c.)
FACTORY WIRE LOOM
TO BYPASS VALVE
& PAXTON ECU