Paxton Superchargers Dodge SRT-10 Ram User Manual
Page 27
7-3
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
Fig. 7-i
Fig. 7-k
Fig. 7-j
Fig. 7-h
D.
For ease of installing the water tank, remove
the lower panel that is attached to the front
air dam.
E.
Locate the small angled bracket and the self-
tapping sheet metal screws that are provided
in the water tank mounting assembly. This
bracket will be attach to the passenger’s side
inner fender between the front radiator core
supports. (See Fig. 7-i.)
I.
Route the hose to the outlet of the water
pump. This hose should be approximately
42" in length. (Check its fitment before cut-
ting to length.) In one end of the hose com-
ing from the heat exchanger, install one 3/4"
hose mender and secure with a nylon clamp.
J.
Install the hose to the 90º that was attached
to the water pump in an earlier step. Secure
the hose with a nylon clamp.
K.
At the heat exchanger, attach a length of
3/4" hose with a clamp to the 90º barbed fit-
ting closest to the passenger’s side of the
vehicle. This hose should be approximately
86" in length. (See Fig. 7-k.)
L.
Attach the other end of the hose to the 90º
barbed fitting located on the charge air cool-
er. It should be attached to the fitting located
closest to the intake manifold. Secure with a
nylon clamp.
M.
These hoses should be routed away from
any hot or sharp objects.
F.
Attach the triangle water tank to the bracket
that was installed in the last step using the
1/4" x 1/2" bolts and washers that are pro-
vided.
G.
Install one of the provided 4" x 12" x 90º
long hoses to the water pump using a nylon
clamp. (See Appendix A-5.)
*** NOTE ***
This formed hose may need to be trimmed to fit.
H.
Attach a length of 3/4" hose to the 90º
barbed fitting located on the farthest side of
the heat exchanger. (See Fig. 7-j.)
H.
Attach a length of 3/4" hose to the 90º
barbed fitting located on the farthest side of
the heat exchanger. (See Fig. 7-j.)
WATER TANK MOUNTING
BRACKET LOCATION