Televes COAXDATA GATEWAY 1Gbps - Manual (Page 10)

Data Over Coax Gateway Ref.769301
WPS Button
WPS
(Wireless protected setup) allows the easy configuration of a wireless secure connection with other
devices supporting the WPS protocol. Simply push the button and activate the WPS function on the
wireless device.
The WPS function will be active for 2 minutes, during this period of time the client should stablish a
secure connection.
While the WPS mode is active the power LED will blink orange, once the connection has been finalised
the WPS mode will stop and should a connection to a different device be needed the WPS button should
be pressed again.
WiFi switch
El conmutador WiFi allows three positions and hence WiFi status:
 OFF (left ): radio is off, LED will bright red. .

Low Power
(Center): WiFi radio will be on in low power mode. This mode will reduce exposure to
radiation and interference in nearby networks. The maximum radiated power will not exceed
3dBm. In this mode the WiFi LED will bright orange.

Normal
(Right): WiFi radio will be on in normal mode. The maximum radiated power will be of 17
dBm In this mode the WiFi LED will bright green.
EN
www.televes.es