WaveWare comPPage PIA-3264 - Manual (Page 13)

Paging Interface Adapter
13
Create Default File
All programming is inputted on the Master unit. The Slave only has to have a Unit ID and
Total number of Contacts identified.
Voltage Input
Start on Zone input #1
1. Select the Configuration of inputs.
a. Voltage
2. Select the Type of inputs. (see page 10 for definition)
a. Voltage Alert High
b. Voltage Alert Low
3. Enter Room No. 1-9999, if applicable
4. Enter Active Message
This is the message that will be sent to the pager when the zone is activated.
5. Enter Reset Message
This is the message that will be sent to the pager when the zone is reset.
Ie..Zone1 Alarm RESET or CANCELLED
6. Select the correct Pulsing rate from the Host System. (If applicable)
If not selected, the Pulse Message will not be available.
a. Slow – 880 m/s +/- 10%
b. Fast – 440 m/s +/- 10%
c. Enter Active Message if Pulsing is used.
7. Enter the message to be sent to the pager when Pulse 1 and Pulse 2 is activated.
8. If Shift was not checked on the Global Setting Page only shift 1 pager and Escalation
pager in the first column will be active. If Shift was selected on the Global Setting,
all three columns will be available.
a. Pagers for Shift 1 are shown on the first row .
b. Pagers for Shift 2 are shown on the second row.
c. Pagers for shift 3 are shown on the third row.
d. The Escalation pager ID is Global for all three shifts by call type.