WaveWare comPPage PIA-3264 - Manual (Page 6)

Paging Interface Adapter
All IP addresses on a network or stand alone PC must have the same IP address string. Ie.. 192.168.1.100
and If your system does not support the IP series 192, which is the IP string address the PIA is shipped with
and can be found on the mother board. You must re-assign the PIA IP address to one that is compatible
with your network or PC or change the IP address on the PIA. This can be done by following the steps
below.
Note: Be sure to check with your network administrator before proceeding.
CHANGING PC IP ADDRESS
1. Locate the IP Address on the main board of the PIA3264, you will need to assign a
sequential number to the PC you are using to program the PIA.
2. Locate and Change IP Address.
a. Select Start, Connect To, Show all Connections.
6
3. Right click on your Local Area Connection and select Properties.
4. Right click Internet Protocol (TCP/IP) and select Properties.
5. Select Use the following IP address. This will un-select Obtain an IP address
automatically.
6. To the right of the IP address enter your new IP address. Be sure it matches the IP address
that is on the PIA. The Subnet mask should be 255.255.255.0. Select OK to exit the screen .
7. Re-boot your PC and you are ready to log onto the PIA.