Argox OS Series - Manual (Page 17)

32
Parallel Interface Requirements
The required cable (IEEE 1284-compliant is recommended) must
have a standard 36-pin parallel connector on one end, which is
plugged into the parallel port located on the back of the printer.
The other end of the parallel interface cable connects to the
printer connector at the host computer. For pin-out information,
refer to the Reference Technical Information, Interface
Specification.
OS-214plus
Power Jack
RS 232 Serial Port
Parallel Port
USB Port
33
Ethernet Interface
This connector is for Ethernet application; it is convenient to use
several printers by Ethernet connector at the same time.
Notes:
When using Ethernet model printer, please wait till the Ready
Indicator to stop blinking and then can start to use printer.
OS-2140E
RS-232 Serial Port
Ethernet Port
(OS-2140E Model) USB Port