Argox OS Series - Manual (Page 28)

54
13. After driver installation is complete, click "Close".
The driver should now be installed.
Installed printer Argox OS-2140 PPLA
55
Troubleshooting
Normally, when the printer is in not working properly, the "Power"
LED blinks continuously; while printing and communication
between the host and printer stops.
LED Diagnosis
Power and Ready LEDs blinking continuously indicates printer
errors. To understand the problem, please observe the Power and
Ready LEDs and refer to the following solutions:
LED Indicators: Power and Ready LEDs blink at the same tempo
Power LED
Ready LED
ON ON
OFF OFF
Possible Problems Solutions Remarks
Miss-detect gap
Check the label path
Check the label sensor If you use a
continuous label roll
and run under
Windows, select
continuous media.
Label stock out Supply the label roll
Label stock not
installed Install the label roll
Label jam Recover the jam