Argox OS Series - Manual (Page 42)

82
6. Secure the four screws attaching the cutter.
7. Plug the cutter's connector into the PCB's header
connector (J9).
8. Reattach the print head assembly by securing the 4
screws.
9. Click back the middle cover.
10. Secure the two screws for the base housing.
11. Click the top cover into place.
Cutter
83
Appendix II - Installing the Extension Card
Extension Card designated for all optional extension modules.
For example, RTC card and Add-on card.
Install the extension card into the printer as follows:
1. Turn off the printer power.
2. Remove the top cover.
3. Release the two screws at the bottom of the base housing.