Argox G-6000 - Manual (Page 26)

Vertical streaks in the printout usually indicate a dirty or faulty print
head. Clean the print head first, if they still persist, replace the print
head.
51
MEMORY FULL . Check the graphics and soft fonts
from host.
. Make sure to delete the graphics
and soft fonts if they are no longer
used by
the application software.
(Refer to the Technical R eference
Manual for details).
Note:
After the problems have been solved, press CANCEL to continue printing.
D. Miscellaneous
♦
♦
♦
52
♦
♦
Unstable ribbon roll rotation.
Check the label path and make sure the head latch is securely
closed.
Poor printout quality.
. The ribbon may be not qualified.
The host shows “Printer Time out” . 。 . The media may be not qualified.
. Adjust the Darkness (heat temperature).
1. Is the communication cable (parallel or serial) connected
securely to your parallel or serial port on the PC and to the
connector on the printer ? . Slow down the print speed.
. Refer to the following paragraphs and clear the related modules.
2. Is the printer power turned on ?
If the power cord is connected, the power switch is at position
‘1’ and the power LED is still not illuminated, call for service.
The data has been sent, but there is no output from the printer.
Check the active printer driver, it should be Label Dr. for your
Windows system and the label printer.
Check the emulation and the print (command) file.
Recovery