Argox G-6000 - Manual (Page 8)

Peel Off Mode
Follow the common procedure of “ Loading the Media “ of Standard
Mode from step 1 to 3.
4. Remove approximately 6” long labels from the label
backing paper
( Figure 11 )
5. Lead the backing paper through the print head module. ( Figure 12 )
6. Turn back under the print head module. ( Figure 13 )
7. Use a sticker to fix the media on the rewinder kit.( Figure 14 )
8. Turn the rewinder kit twice to ensure the media is firmly fixed. ( Figure
15 )
9. Close the side access door and turn on the printer or press the FEED
button if the printer is already on. ( Figure 16 )
Notes:
1. The “ FEED “ button will not drive the printer to peel. The peeling work
can be executed only when (1 ) the software setting is ready; (2) Bit 5
of DIP switch at real panel must be set to ON position.
2. Please sure the peeler sensor is out of ribbon path when it’s installed.
16
11
Backing Paper
12
Print Head Module
15