ART Pro Audio USB Phono Plus - Project Series User Manual
Page 15
15
SPECIFICATIONS:
Frequency Response:
10 Hz – 50 kHz, +/- 0.5%
THD:
<0.01% typical @ 1 kHz
Hum and Noise:
>90 dB below clipping
Input Impedance:
47k Ohms/100pf (phono), 270k Ohms (line)
Maximum Input Level:
40 mV rms @ 1 kHz (phono), +19dBu (line)
Maximum Gain:
45dB @ 1 kHz (phono), 6dB (line)
Analog Input Connections:
RCA (preamp / phono/line output)
Analog Output Connection:
RCA (preamp line output)
1/8” (monitor/headphone output)
Maximum Output Level:
+6dBu (1.4V rms)
Filter Type / Response:
Switchable, high pass (low cut) –3dB @ 22 Hz
A/D-D/A:
16 bit, 44.1 kHz or 48 kHz, USB selectable from computer
0.4 ms A/D latency @ 44.1 kHz
Digital Audio Interface
TOSLINK Opto In to USB,
TOSLINK Opto Out from USB,
S/PDIF coax (RCA) In to USB
Computer Interface:
USB 2.0 compliant
Chassis Type:
All aluminum black anodized with integral rubber sides
Power Requirements:
USB bus powered or
7-12V DC or 9-12V AC @ 150mA (external)
Either polarity of the tip will work with DC power
Dimensions:
1.85 x 4.6 x 4.5 (in)
47 x 117 x 114 (mm)
Weight:
1.35 lbs, 0.61 kg
Note: 0 dBu = 0.775Vrms
ART maintains a policy of constant product improvement.
Therefore, specifications are subject to change without notice.
Go to
for the latest information and on the Project Series
USB Phono Plus.