ART Pro Audio USB Phono Plus - Project Series - Manual (Page 7)

7
USB COMPUTER SETTINGS:
Once the USB connection is made and your computer is on, your computer will power the USB
interfaces circuitry over the USB bus and the unit will automatically connect and try to set your com-
puter “Default Audio Device” to be “USB Audio CODEC”. Usually the computer will do this automati-
cally whenever a USB device is first connected, but it is sometimes necessary to make the selection
manually. The same settings may need to be made in your particular audio application as well (Check
your application instructions). These settings should be made while the USB Phono Plus and com-
puter are connected and powered on. Select one of the following Operating System choices:
WINDOWS 7:
Start=> Settings => Control Panel => Sound => Playback Tab and Recording Tab
Choose: “USB Audio CODEC”
Then: Recording Tab=>Properties=>Advanced and change Default Format to: “2ch, 16bit, 44.1kHz”
Also choose: Recording Tab=>Properties=>Levels and set the level to “4”
WINDOWS VIsta:
Start=>Settings => Control Panel => Sound => Playback Tab and Recording Tab
Choose: “USB Audio CODEC”
Then: Recording Tab=>Properties=>Advanced and change Default Format to: “2ch, 16bit, 44.1kHz”
Also choose: Recording Tab=>Properties=>Levels and set the level to “25”