Artesyn ATCA-7368 Installation and Use (June 2014) User Manual
Atca-7368
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- ATCA-7368
- Contents
- Safety Notes
- Sicherheitshinweise
- About this Manual
- Introduction
- Hardware Preparation and Installation
- Controls, Indicators, and Connectors
- BIOS
- 4.1 Overview
- 4.2 Accessing the Blade using the Serial Console Redirection
- 4.3 Changing Configuration Settings
- 4.4 Boot Options
- 4.5 Redirection of I/O
- 4.6 LED behavior during POST
- 4.7 LED Usage
- 4.8 RTM SAS Controller
- 4.9 Board Information Display
- 4.10 USB Ports
- 4.11 Supported Operating Systems
- 4.12 Persistent Memory Module
- 4.13 Upgrading the BIOS
- 4.14 BIOS Error Messages
- 4.15 BIOS Status Codes
- Functional Description
- 5.1 Overview
- 5.2 Block Diagram
- 5.3 Processor
- 5.4 Memory
- 5.5 Chipset
- 5.6 I/O Controller
- 5.7 Persistent Memory Module (PMEM)
- 5.8 Ethernet Ports
- 5.9 Storage
- 5.10 IPMC
- 5.11 Serial Redirection
- 5.12 Serial Over LAN
- 5.13 IPMI Over LAN
- 5.14 USB 2.0 Interface
- 5.15 SMBus Connections
- 5.16 Real Time Clock
- 5.17 Single Width Mid-size AMC
- Serial Over LAN
- Supported IPMI Commands
- 7.1 Overview
- 7.2 Standard IPMI Commands
- 7.3 PICMG 3.0 Commands
- 7.4 Artesyn Specific Commands
- 7.5 Pigeon Point Specific Commands
- 7.5.1 Get Status Command
- 7.5.2 Get Serial Interface Properties Command
- 7.5.3 Set Serial Interface Properties Command
- 7.5.4 Get Debug Level Command
- 7.5.5 Set Debug Level Command
- 7.5.6 Get Hardware Address Command
- 7.5.7 Set Hardware Address Command
- 7.5.8 Get Handle Switch Command
- 7.5.9 Set Handle Switch Command
- 7.5.10 Get Payload Communication Time-Out Command
- 7.5.11 Set Payload Communication Time-Out Command
- 7.5.12 Enable Payload Control Command
- 7.5.13 Disable Payload Control Command
- 7.5.14 Reset IPMC Command
- 7.5.15 Hang IPMC Command
- 7.5.16 Graceful Reset Command
- 7.5.17 Get Payload Shutdown Time-Out Command
- 7.5.18 Set Payload Shutdown Time-Out Command
- 7.5.19 Get Module State Command
- 7.5.20 Enable Module Site Command
- 7.5.21 Disable Module Site Command
- 7.5.22 Reset Carrier SDR Repository Command
- FRU Information and SDR Summary
- A Replacing the Battery
- B Related Documentation