Artesyn ATCA-7368 Installation and Use (June 2014) - Manual (Page 72)

BIOS
ATCA-7368 Installation and Use (6806800M12D) 72
4.4.1 Supported Boot Devices
The BIOS supports booting from the following devices/sources:
 USB Devices (Sticks, onboard embedded USB flash disk, Hard Drives, CD-ROM)
 SAS controller on ARTM
 Fibre Channel Controller on ARTM
 Network (BEV)
 AMC SATA & SAS HDD
 Onboard embedded SDD
Default boot order:
 Attached USB CDROM
 Removable dev (if applicable)
 Attached USB devices of USB external port
 SAS HDD connected to ARTM SAS Controller
 Base Ethernet Interface
 EFI shell
In case BIOS does not find any ready bootable device, it may loop on the source list until any
boot device becomes ready or watchdog bites.
4.4.2 Selecting The Boot Device
There are two possibilities to determine the device from which BIOS attempts to boot:
 By setup to select a permanent order of boot devices
 By boot selection menu to select any device for the next boot-up procedure only