Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 126)

Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E) 126
5.7.5 PMC I/O Modules
CPCI-6200 SBC supports two single-wide PMC sites. Each site provides four 64-pin EIA-E700
AAAB connectors to interface to a 32/64-bit IEEE P1386.1 PMC. One of the four connectors is
dedicated to user I/O. Two PMC I/O modules are supported on the CPCI-6115-MCPTM, one per
PMC site on the CPCI-6200 SBC. The CPCI-6200 SBC maps the PMC user I/O pins onto the
CompactPCI J3 and J5 connectors. The CPCI-6115-MCPTM reverses the mapping and brings
the signals to a 64-pin EIA-E700 AAAB connector to interface with the PMC I/O module. This
causes a one-to-one correspondence in the pinout between the PMC on the CPCI-6200 SBC
and the PMC I/O module on the CPCI-6115-MCPTM. Refer to the section titled PMC I/O Module
for a detailed description of PMC I/O modules.
5.7.6 Asynchronous Serial Ports
The CPCI-6200 SBC contains two asynchronous serial ports that are routed to the J5 user I/O
connector. Serial port 1 (COM1) is also wired as an RS-232 interface to an RJ-45 connector on
the front panel. A jumper (J6) on the CPCI-6115-MCPTM enables the COM1 port either on the
CPCI-6200 SBC or the transition module. One version of the CPCI-6115-MCPTM employs four
RJ-45 connectors on the rear panel of the transition module for COM1, COM2, COM3 and
COM4 respectively. Note: only COM1 and COM2 can be used.