Artesyn ViewCheck on ATCA-9405 Installation and Use (May 2014) - Manual (Page 35)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51C) 35
Installing the ViewCheck Service OS image on SP
Before installing the ViewCheck service OS Image, you should have the knowledge of
configuring TFTP Server, configuring ATCA-9405 for Network Booting and Booting ATCA-9405
using a ramdisk. For more information, refer to the section 2.3 in Blade Services Software on
ATCA-9405 PR guide.
1. Once the blade is configured to boot with ramdisk image, it will have ViewCheck,
Orion License utils, and Blade Services Framework installed.
2. Generate the Activation record to start using the ViewCheck application. For more
information, see Obtaining the Activation Record on page 22 .
3. SP should also have the interfaces to PP1 and PP2 configured so that a
communication can be established between SP and PP's.
4. After the activation record is placed, first restart the BSF services on 9405 SP and
then on 9405 PP as below:
sh /opt/ssf/etc/config/S99SsfBsfRun.sh restart
5. The license generated can be exported to TFTP server to avoid copying of activation
records into the blade for every reboot of OOSD image. To export license, run
/etc/rc.d/init.d/exportLicense.sh
/etc/rc.d/init.d/exportLicense.sh
Please enter the TFTP server to store the license
files[xxx.xxx.xxx.xxx]: 192.168.21.1
Please enter username: root
Make sure that vsftpd daemon is running on the blade. Otherwise, you can start using
command, service vsftpd start.