Artesyn ViewCheck on ATCA-9405 Installation and Use (May 2014) - Manual (Page 38)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51C) 38
Username: Admin
Password:
Access granted
>enable
#configure terminal
BSF(config)#
4. Select Virtual Execution Environment as below:
 On SP, use the virExecEnv SP_VEE0 options in the virExecEnv
BSF(config)#virExecEnv virExecEnv SP_VEE0
BSF(VEE-SP_VEE0)#diagnostic
BSF(diag-SP_VEE0)#
 On PP, use the OCTEON1_VEE0/OCTEON1_VEE1 options in the virExecEnv
BSF(config)#virExecEnv OCTEON1_VEE0
BSF(VEE-OCTEON1_VEE0)#diagnostic
BSF(diag-OCTEON1_VEE0)#
After logging into the ViewCheck CLI, you can list all the commands supported by typing '?'
on the CLI console. For information on commands to be used to install and LOG to ViewCheck,
refer
Commands Execution on page 55 .
BSF(diag-SP_VEE0)#?
configure-error-strings User configurable error strings, notified
by ViewCheck when reported by the device.
configure-log-path Configures the log path where the resluts
are stored.
device-category Configure deviceCategory
diag-service Diag operation(start/stop/restart).
exit Exit from diagnostic
hw-inventory-list Provides the Inventory of Hardware (Type,
Vendor ID, Major Number, Minor Number and
any associated Details) as detected by the
By default, the administrator user name and password are "Admin".