Maintaining your appliance 35, Monthly maintenance (while appliance is in use), Door and glass inspection – Avalon Firestyles Olympic User Manual

Page 35: Creosote - formation and need for removal

Advertising
background image

Maintaining Your Appliance

35

© Travis Industries

93508061

4150520

Monthly Maintenance (while appliance is in use)

Make sure the appliance has fully cooled prior to conducting service.

Door and Glass Inspection

The door must form an air-tight seal to the firebox for the stove to work correctly. Inspect the door gasket
to make sure it forms an air-tight seal to the firebox.

The door can be lifted off the hinges if extensive repairs are conducted.

The door latch should pull the door against the face of the stove (but not so tight as to not allow full
handle rotation). If the latch requires adjustment, follow the directions below.

Creosote - Formation and Need for Removal

When wood is burned slowly, it produces tar and other organic vapors, which combine with expelled
moisture to form creosote. The creosote vapors condense in the relatively cool chimney flue of a slow-
burning fire. As a result, creosote residue accumulates on the flue lining. When ignited, this creosote
makes an extremely hot fire. The chimney and chimney connector should be inspected at least once
every two months during the heating season to determine if a creosote buildup has occurred. If creosote
has accumulated, it should be removed to reduce the risk of a chimney fire.

If you are not certain of creosote inspection, contact your dealer or local chimney sweep for a full
inspection. Excess creosote buildup may cause a chimney fire, that may result in property damage,
injury, or death.

Severely frayed or thread-bare

gasket should be replaced.

Use wood stove gasket

cement to re-adhere

loose gasket.

If the glass is damaged, replace

it - see “Replacement Parts” for

details.

High-Temperature anti-sieze

may be used on the door

hinges to eliminate squeaks.

Door Cam

Door
Handle

Washers

Door Frame

Use a 9/16"
socket wrench to
remove this nut.

Side View of Door Handle

Door Cam
Adjustment:

To tighten, remove
a washer from the
inside of the door
frame. To loosen,
place an additional
washers on the
inside of the door
frame or loosen
the nut 1/2 turn.

Exploded View

Advertising
This manual is related to the following products: