Avery Dennison 9400 Series Programmer Manual - Manual (Page 61)

This value is measured in tenths of
millimeters (TOMMS) and must be less
than the maximum length of the supply.
Values: 0-2032
COLUMN
One to four digits to define the column
location of the field on the supply. This is
the distance from the guide edge zero
point at the
left edge of the supply and the
left edge of the field.
The zero point is 1.5 mm or 0.060 inches
from the left edge of the supply.
The unit of measurement is tenths of
millimeters. The range must be less than
the maximum width of the supply.
Values:
9425 0-508 (0 to 2 inches)
9445 0-1016 (0 to 4 inches)
9465 0-1016 (0 to 4 inches)
9474 0-1016 (0 to 4 inches)
The following format data stream uses the graphic data
defined earlier in this chapter. The graphic is inserted 20 mm
from the bottom and 20 mm from the left edge of the supply.
{
F11,550,507;LETTER-A
p
G1,200,200
p
T0,I,0,400,100,1,1,0,0,B
p
}
Usi
n
g
G
rap
h
ics
5. Using Graphics
5-9