Aviosys 9216 - Manual (Page 10)

IP SENSOR 9216 USER MANUAL
5. Initial Settings
Initial setting through the Ethernet
1. Double click the Edit.exe :
2. All the IP 9200 series, IP Kamera 9000
series/IP Video 9100 series in the same subnet
of the Ethernet will be found and be display in the
window by the software. The default name of IP
SENSOR 9216 is IP TERMINAL . The default
IP address of 9216 is fix at 192168.100.100.
3. Click the equipment‘s name that you want to edit in the left of the window; it will turn fuscous, the
equipment’s name and IP address will display in the windows, you can rename (use numbers and letters). After
that, click the update button and the new setting will be work in 20 seconds.
4. Double click the name of the equipment you want to control, the IE browser window will open and connected
to this equipment in that Ethernet automatically. You also can type the IP address of the 9216 in the IE browser
to open the web page of 9216. We suggest you to update the IE to version 6.0 with SP1 or higher if your IE
notices you the security level is too low to open that web page.
NOTICE:
1. IP Sensor 9216 default setting is fixed IP address: 192.168.10.100. The IP address of your computer
should in the same subnet with that of IP Sensor 9216, so that you can open the control web page. In
the figure above, the IP address of 9216 is 192.168.100.168. You can make sure the IP address of
your computer first, then use the ipedit.exe to modify the IP address of 9216. after that, your
computer can connect to the 9216.
2. IF user can not enter the control web page, please set the IP address of IP Sensor 9216 and your
computer in the same subnet. User can obtain the computer’s IP address, subnet mask, and default
gateway through the following method.
start run type in “cmd” then open the MS –DOS window, now type in “ipconfig”
1.0, - 9 - VER.