Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 17)

T
H
R
E
A
D
I
N
G
15
Left Needle C-1
1. Raise presser foot and place the thread on the far left spool pin. Slip the thread into the telescopic
antenna thread guide directly above the thread spool. See drawings below for reference.
2. Bring thread down from the telescopic antenna, snap thread into the orange thread guide on the
top of the machine, and then down into the orange hole above the tension dial.
3. Bring the thread down the right side of the orange tension dial, under the dial and back up the left
side, making sure the thread is in the tension disk.
4. Bring the thread through thread guide at top of machine and down to the pre­tension thread guide
above the needle.
5. Pass the thread from the left side behind the pre­tension thread guide plate on needle clamp and
into thread guide above the needle. See drawings below for reference.
6. With the needle threader or tweezers in the accessory compartment, thread needle in the left "C­1"
needle position.
Center Needle C-2
1. Raise presser foot and place the thread on the second from the left spool pin. Slip the thread into
the telescopic antenna thread guide directly above the thread spool. See drawings below for refer­
ence.
2. Bring thread down from the telescopic antenna, snap thread into the yellow thread guide on the top
of the machine, and then down into the yellow hole above the tension dial.
3. Bring the thread down the right side of the yellow tension dial, under the dial and the thread guide
below the dial.
4. Bring the thread through thread guide at top of machine and down to the pre­tension thread guide
above the needle.
5. Pass the thread from the right side behind the pre­tension thread guide plate on needle clamp and
into thread guide above the needle. See drawings below for reference.
6. With the needle threader or tweezers in the accessory compartment, thread needle in the center
"C­2" needle position.
Right Needle C-3
1. Raise presser foot and place the thread on the back right spool pin. Slip the thread into the tele­
scopic antenna thread guide directly above the thread spool. See drawings below for reference.
2. Bring thread down from the telescopic antenna, snap thread into the green thread guide on the top
of the machine, and then down into the green hole above the tension dial.
3. Bring the thread down the right side of the green tension dial, under the green dial and under the
thread guide located below the yellow tension dial.
4. Bring the thread through thread guide at top of machine and down to the pre­tension thread guide
above the needle.
5. Pass the thread from the right side behind the pre­tension thread guide plate on needle clamp and
into thread guide above the needle. See drawings below for reference.
6. With the needle threader or tweezers in the accessory compartment, thread needle in the right "C­
3" needle position.
NOTE:
After threading the needles, the thread is then place to the left and top of the presser foot.
Chain / Cover Needles
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:58 ページ 15