Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 35)

S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
33
1. Open the front cover and raise the presser foot.
2. At the threading port, cut the chain looper thread. Remove
chain looper thread from under the presser foot and the upper
thread guides. Replace cone of thread with specialty thread.
3. Place the machine in "locked" position to thread the chain
looper.
4. Thread specialty thread into the upper thread guides, leaving
an 18­inch (40cm) tail above the threading port.
5. Place the straight end of the looper threading tool into the
threading port. Push the looper threading tool until the end
comes out of the looper eye. Open side door of machine to
see threading tool come out of the eye of chain looper.
6. Insert the specialty thread tail into the looper threading tool
eye (fig.A). Pull the straight end of the looper threading tool
through the looper eye bringing the specialty thread with it.
(fig.B)
7. Cut chain looper thread to 4 inches (10cm) and place in tray.
Close the side door of the machine.
Looper Threading Tool
A
B
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:59 ページ 33