Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 42)

Your Baby Lock will operate at best performance if it is kept clean at all times.
Your Baby Lock's major moving parts are well protected and do not need to be oiled.
However, we recommend to use the cleaning brush often during garment construction in order to keep
lint off, the needle bar, the feed dog mechanism and looper. If machine needs to be oiled, check with
your nearest Baby Lock retailer for use of high grade recommended sewing machine oil.
TO REMOVE NEEDLE PLATE PROCEED AS FOLLOW:
1. For safety reasons, unplug main power cord.
2. Raise and remove presser foot.
3. Remove needles from needle clamp.
4. For easy access to the needle plate lock pin set screw, raise needle clamp to its highest position.
(fig. A).
5. Place allen screwdriver (1.5mm) into allen screw and loosen needle plate pin holder screw. See (fig.
B) for location of screw.
6. Remove needle plate lock pin (fig. B) and remove needle plate front screw.
7. Open left side cover of machine and remove needle plate.
8. Clean machine. (fig. C)
9. Place needle plate onto machine and insert needle plate lock pin.
10. Tighten allen screw needle plate lock pin and check and make sure that top needle plate lock pin is
flush with needle plate.
11. Place needle plate front screw and tighten screw.
Note: For better stitch performance, make sure needle C­1.C­2,and C­3 do not touch either side of
needle plate hole.
A B
C
M
A
I
N
T
E
N
A
N
C
E
40
Cleaning
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:59 ページ 40