Baby Lock Cover Stitch (BLCS-2) Instruction and Reference Guide - Manual (Page 39)

Stitch Unbalanced:
1. Is the machine threaded correctly?
2. Is the proper presser foot on the machine?
3. Is the correct needle inserted and threaded?
4. Is the thread in the tensions?
5. Are the tensions set correctly for the chain/cover needles?
6. Is the tension dial set correctly for the chain looper?
7. Is the chain looper threaded correctly?
8. Is the needle thread(s) in the correct tension disk?
Looper Threading Difficulties:
1. Is the thread end in the threading port correctly?
2. Is at least 1 inch (2.5cm) of the thread end in the threading port?
3. Is there at least 18­inches (40cm) of loose thread beyond the thread guide above the threading
port?
4. Is there a kink or twist in the 18 inch (40cm) of thread to restrict the flow into the threading port?
5. Is the thread caught to prevent going through the chain looper?
M
A
I
N
T
E
N
A
N
C
E
37
Troubleshooting (Cont.)
★New_BLCS-2 Ta:BLCS-2 En.qxd 2009/05/25 16:59 ページ 37