Baumatic BO920TS - Manual (Page 40)

Italiano
Français
Deutsch
Español
Nederlands
Português
37
English
The end of cooking, established by reaching the internal temperature set for the food
probe. All the oven programming functions (timer functions) are stopped, apart from
the beeper (minute counter).
When the food probe senses the temperature for which it has been set, the oven is
automatically deactivated and you will hear a beep!
When the cooking time is up, remember to disconnect
the food probe and remove it from the oven.
CautION: the probe is very hot after cooking.
If the probe is left connected to the oven but not inside
the food, an error may be generated (ERR3) on the
timer display. The error will disappear when the probe is
disconnected from the oven.
sPECIaL FuNCtIONs
Boost (quick preheat)
This special function can be activated after selecting a cooking function and is used to
reduce the time required to reach the set cooking temperature.
This period of time is known as preheating, and is required in practically all recipes.
It is possible to disconnect the turbo heat function or change cooking function at
any time.
Clean (quick cleaning)
Correct operation is combined with the use of the lateral panels and catalytic fan cover:
the oven is treated with special enamel with a micro-porous structure, which breaks
down the fat projected thanks to a catalytic oxidisation process which transforms
residues into gaseous products.
The turbo clean function is only activated when no cooking function has been selected,
so: switch on the oven and touch the symbol as shown in the figure for five seconds.