BUG-O Systems CWP-18 - Manual (Page 6)

6
INTRODUCTION
The CWP-18 (CWP-1800) Programmable Circle Welder is designed for contour welding of
nozzles into vessels or domed heads utilizing SUB-ARC, MIG or FLUX CORED PROCESS,
with gas shielding. The CWP-18 mounts on a 3-Jaw Chuck welding diameter 6" to 50" O.D.
FEATURES
• Wire feeder with one set of drive rolls
• 1/12 HP P.M. motor and rotational speed control
• 600 AMP gun & cable assembly
• 50 ft. (15 m) power cable
• 50 ft. (15 m) gas shielding hose
• 50 ft. (15 m) weld cable
• Quick disconnects for all cables
• Pre and post flow controls
• Wire reel adaptor for 60 lb. (27 kg) spools
• Motorized vertical and horizontal torch positioning system
• Microprocessor controlled rise and fall with 7" (175 mm) of travel
• Brushes and collector rings for welding current, rated at 600 AMPS 100% duty cycle
• Brushes and collector rings for all controls, eliminates cable and hose wrap
NA 3 CONTROL PROVIDES
• Wire Speed (amperage) control
• Voltage Control
• Wire burn back
• Weld contact
• Cold wire inch switch
• Weld start parameter adjustment
• Weld Crater parameter adjustment
TECHNICAL DATA
Control Voltage: 115 VAC
Amperage: 0-600 amps
Voltage: 0-50
Wire Sizes: 1/16"-7/32" (1.6-5.6 mm)
Rotation Speed: .06-0.72 rpm
Vertical Travel: 0"-7" (0-175 mm)
Welding Diameter: 10"-50" (254-1270 mm)
Shielding Gas: SolenoID Control
Height: 43" (1092 mm)
Net Weight: 360 lbs. (163.6 kg)
Shipping Weight: 490 lbs. (222.3 kg)