Hardware installation, Physical details, Rear panel – ConnectGear WA300 User Manual
Page 7: Hysical, Etails, 11mbps wireless access point user's manual
11Mbps Wireless Access Point User's Manual
2.Hardware Installation
Physical Details
Rear Panel
Antenna Connection
LAN Connection
INIT Button
LAN Cable
Selection Switch
Power Input
Antenna Connection
Please install the dipole antenna directly into the reversed SMA
connector of AP. After AP start to work, you may adjust the angle of
the antenna or reposition the AP to get a better performance and
reach.
INIT Button
“INIT” mean “Initiation”. While pressing the button, the AP will
reboot and reset current settings to factory default settings. The left
indicator “DIAG” on AP will be off and then begin blinking. Then
this initiation action will be completed when the indicator “ DIAG” is
always green instead of blinking.
LAN Cable
Selection Switch
X
Crossover: the RJ-45 port Tx and Rx lines are
reversed. Use this setting when you have a straight
cable connected. It is also the factory default
setting.
II
Straight: the RJ-45 port Tx and Rx lines are normal.
Use this setting when you have a crossover cable
connected.
Power Input
Only use the power adapter supplied with the Access Point
7