Crest Electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL - Manual (Page 25)

25
and increase from there as the UP ARROW key is held. Use the t and u keys to
set the Start Speed of the locomotive.
l.AUX FUNC. SETUP
- This menu item is used to set each of the function
keys to operate either as momentary or
latching. MOMENTARY means that the
function being controlled is on while the
Function key is pressed and turns off when
the key is released. LATCHING means
that the function being controlled is turned
on when the Function key is pressed and
remains on till the same Function key is
pressed again.
AUX MODE: BASIC
vs. EXTEND
- Select either BASIC or EXTEND. In
BASIC mode, you will be able to control function keys F1 thru F6. If your
receiver supports more than six auxiliary functions then EXTEND mode is
chosen so that you can control up to 16 auxiliary functions, F1 thru F16.
Use the t and u keys to set each Aux Function to either momentary or latching.
m.LINKING
- This final menu item is used to establish a Link between the
transmitter and the receiver that you just defined.
1) Press and hold the Link Switch on the receiver or locomotive until the LED
on the receiver, or lights on the locomotive, begin to flash.
2) While the LED/lights are flashing press the ENTER key on the transmitter.
In a moment the screen will show that the programming of the unit has been
successful and the flashing will stop. Once linked, the function settings are saved for
this locomotive. Press MENU to return to the Main Menu.
2.USAGE OF CABS
The Revolution transmitter can store up to as
many as 50 locomotives. Since it is unlikely
that each of us would have this number of
locomotives active at one time you can use this
menu item to limit the number of locomotives
that show up when you press the <<T and T>>
keys while viewing the control screen.
1) From the Main Menu screen use p and q
to select 2.USAGE OF CABS and press
ENTER
2) Use the t and u keys to increase or
decrease this range from CAB-0 thru
CAB49.
Press MENU to save this set-up and return to
the Main Menu.
AUX FUNC. SETUP
AUX MODE: BASIC
F1: MOMENTARY
F2: MOMENTARY
F3: MOMENTARY
F4: MOMENTARY
F5: MOMENTARY
F6: MOMENTARY
MAIN SET UP
1.ASSIGN FUNCTION
2.USAGE OF CAB ¤
3.ADD MU/SU
4.COPY LOCO
5.SYSTEM CONFIGURE
2.USAGE OF CABS
CONTROL CAB
CAB-0 TO CAB-5