Crest Electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL User Manual
Page 8
8
1) Remove the locomotive shell. Refer to the manual included with your locomotive
to determine where the DCC/RCC socket is located. Turn the locomotive (or
tender) over, and remove all screws that hold the shell to the frame. Depending
on the model of the locomotive, the number of screws will vary.
2) Remove the jumper plug on the DCC/RCC socket and set it aside. You can
restore the locomotive to its pre-installation state by reinstalling the jumper plug.
3) Install the receiver in the 12 pin DCC/RCC socket and the 10 pin support socket
as shown making sure to match the 12 pin header to the 12 pin socket and the 10
pin header to the 10 pin socket.
Engine Main
Circuit Board
Jumper Plug
12 Pin DCC Socket
10 Pin Accessory
Socket
ENGINE MAIN
CIRCUIT BOARD
12 PIN DCC/RCC SOCKET
10 PIN SUPPORT
SOCKET
TE REVOLUTION
RECEIVER