Daktronics M SERIES - Manual (Page 14)

Using Presets
a) Programming Presets
There are eight presets for each hoist. The presets are
programmed by selecting the POSITION and SPEED
buttons next to each of the eight presets and entering the
desired values using the on-screen keyboard.
b) Preset Operation
Only one preset can be selected at a time. In order to
run a hoist preset, the ENABLE PRESET MOVE button
must be selected. The desired SELECT PRESET button can
then be pressed.
The EXECUTE MOVE button must be pressed and held to
execute the preset move.
c) Clear Current Preset Values
Press Clear Current Preset Values to clear all
preset values to zero.
Press Yes to confirm or No to cancel (Figure 5).
Figure 5: Clear Current Preset Values
14