Daktronics M SERIES - Manual (Page 8)

Daktronics M Series Controller
Control of all hoists is possible from the M Series automation control console or, (depending on installation) a
pushbutton control station. The hoists can be controlled individually and at various speeds. Refer to Sections 4-9 of
this manual for the operating procedures.
WARNING If it is necessary to operate a hoist from a location where the operator's view of the moving
load is obstructed, a second person must be used to observe the load and communicate to
the operator.
Specifications
WARNING The Vortek M Series unit must only be used with a maximum load equal to the capacity stated for
the model below. Overloading the system may result in serious injury or an inoperable system.
THE FOLLOWING MODELS ARE VARIABLE SPEED AND DESIGNATED TO BE CONTROLLED THROUGH
THE DAKTRONICS M SERIES CONTROLLER:
USA (60Hz) M Series Based Models and Applications
M Series Controller- Single Purchase
HOIST MODEL NUMBER LOAD LBS (kg) SPEED FT/MIN (M/SEC)
VM-12180 0—1200 (540) 0—180 (0.9)
VM-14140 0—1400 (635) 0—140 (0.7)
VM-1740 0—1750 (793) 0—40 (0.2)
HM-4020 0—4000 (1814) 0—20 (0.1)
VM-2020 0—2000 (907) 0—20 (0.1)
VM-0820 0—800 (362) 0—20 (0.1)
4