DFI CR908-B - Manual (Page 35)

www.dfi .com Chapter 4 BIOS Setup
35
Chapter 4
CPU PPM Configuration
Enable/Disable Intel
SpeedStep
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Sandybridge PPM Confi guration
EIST
Turbo Mode
Advanced
[Enabled]
[Enabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
EIST
This field is used to enable or disable the Intel Enhanced SpeedStep Technology.
Turbo Mode
The options are Enabled and Disabled.
Device power-up delay
Maximum time the device will take before it properly reports itself to the Host Controller.
“Auto” uses default value: for a Root port it is 100 ms, for a Hub port the delay is taken
from Hub descriptor.
WatchDog Configuration
Enable/Disable IT8518
WatchDog Timer.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
WatchDog1 function
WatchDog2 function
Advanced
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
WatchDog function
This field is used to enable or disable the Watchdog timer function.
Watchdog 1 function
For CR908-B module board (Reset CR908-B by hardware)
Watchdog 2 function
For carrier board usage.