DFI CR908-B - Manual (Page 39)

www.dfi .com Chapter 4 BIOS Setup
39
Chapter 4
Primary Display
Auto When the system boots, it will auto detects the display device.
IGFX When the system boots, it will first initialize the onboard VGA.
PEG When the system boots, it will first initialize the PCI Express x16 graphics card.
Graphics Configuration
Select which of IGFX/
PEG/PCI Graphics device
should be primary display
or select SG for Switch-
able Gfx.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Graphics Confi guration
IGFX VBIOS Version
IGfx Frequency
Primary Display
DVMT Total Gfx Mem
 LCD Control
2132
350 MHz
[Auto]
[256M]
Chipset
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
DVMT Total Gfx Mem
Select DVMT5.0 total graphic memory size used by the internal graphics
device .
LCD Panel Type
Select LCD panel used by Internal Graphics Device by selecting the appropri-
ate setup item.
LCD Control
Select the Video Device
which will be activated
during POST. This has no
effect if external graphics
present.
Secondary boot display
selection will appear based
on your selection.
VGA modes will be sup-
ported only on primary
display.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
LCD Control
Primary IGFX Boot Display
LCD Panel Type
[VBIOS Default]
[VBIOS Default]
Chipset
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit