DFI CR908-B - Manual (Page 43)

www.dfi .com Chapter 4 BIOS Setup
43
Chapter 4
Save & Exit
Reset the system after
saving the changes.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Save Changes and Reset
Discard Changes and Reset
Restore Defaults
Save as User Defaults
Restore User Defaults
Boot Override
P0: ST500DM002-1BD142
Launch EFI Shell from fi lesystem device
Chipset Advanced Main Boot Security Save & Exit
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
Save Changes and Reset
To save the changes, select this field and then press <Enter>. A dialog box will ap-
pear. Select Yes to reset the system after saving all changes made .
Discard Changes and Reset
To discard the changes, select this field and then press <Enter>. A dialog box will
appear. Select Yes to reset the system setup without saving any changes.
Restore Defaults
To restore and load the optimized default values, select this field and then press
<Enter>. A dialog box will appear. Select Yes to restore the default values of all the
setup options.
Save as User Defaults
To save changes done so far as user default, select this field and then press <Enter>.
A dialog box will appear. Select Yes to save values as user default.
Restore User Defaults
To restore user default to all the setup options, select this field and then press <En-
ter>. A dialog box will appear. Select Yes to restore user default.
Clear Administrator or User Password
If you forgot the administrator or user password, follow the steps below to clear the old
password.
1. Power-off the system or turn off the power supply.
2. Set the Clear CMOS jumper to “Clear CMOS” mode. Wait for a few seconds and set the
jumper back to its default setting.
3. Power-on the system. When the “CMOS Checksum Error” message appears, press
<Delete> to enter the BIOS.
4. Select “Save & Exit”. In the “Save & Exit” screen, select “Save Change & Reset” and then
press Enter.
Note:
Using the “Restore Default” function in the “Save & Exit” screen will not clear the old
password. Make sure to follow the steps below.