DFI CD951-C2600 - Manual (Page 12)

www.dfi .com
12
Chapter 2 Hardware Installation
Chapter 2
Power-on Select
1-2 On:
Power-on via power button
(default)
2-3 On:
Auto power-on
JP5
3 1 2
3 1 2
JP5 is used to select the method of powering on the system. If you want the system to
power-on whenever AC power comes in, set JP9 pins 2 and 3 to On. If you want to use the
power button, set pins 1 and 2 to On.
When using the JP5 “Power On” feature to power the system back on after a power failure
occurs, the system may not power on if the power lost is resumed within 5 seconds (power
flicker).
LVDS Panel Select
SW2
SW2 is used to select the resolution of LVDS panel on the system.
LVDS Panel Select Channel SW2
800x600 6/18 bit Single 1-4 On
1024x768 6/18 bit Single 2-4 On, 1 Off
1024x768 8/24 bit Single 1,3,4 On, 2 Off
1280x768 6/18 bit Single 3-4 On, 1-2 Off
1280x800 6/18 bit Single 1,2,4 On, 3 Off
1280x960 6/18 bit Single 2,4 On, 1,3 Off
1280x1024 8/24 bit Dual 1,4 On, 2,3 Off
1366x768 6/18 bit Single 4 On, 1-3 Off
1366x768 8/24 bit Single 1-3 On, 4 Off
1440x900 8/24 bit Dual 2-3 On, 1,4 Off
1400x1050 8/24 bit Dual 1,3 On, 2,4 Off
1600x900 8/24 bit Dual 3 On, 1,2,4 Off
1680x1050 8/24 bit Dual 1-2 On, 3-4 Off
1600x1200 8/24 bit Dual 2 On, 1,3,4 Off
1920x1080 8/24 bit Dual 1 On, 2-4 Off
1920x1200 8/24 bit Dual 1-4 Off
Note:
In order to ensure that power is resumed after a power failure that re covers within a
5 second period, JP9 must be set to pins 2-3 and the “AC Power Lose” in CMOS is set
to “On”.