DFI CD951-C2600 - Manual (Page 9)

www.dfi .com
9
Chapter 2 Hardware Installation
Chapter 2
System Memory
DDR3
Features
• One 204-pin DDR3 SODIMM sockets
• Supports 800/1066MHz DDR3 SDRAM
• Singal channel memory interface
• Supports maximum of 4GB system memory
Installing the DIM Module
1. Make sure the PC and all other peripheral devices connected to it has been powered
down.
2. Disconnect all power cords and cables.
3. Locate the SODIMM socket on the system board.
4. Note the key on the socket. The key ensures the module can be plugged into the socket
in only one direction.
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED lit red, it indicates that there is power on the system
board. Power-off the PC then unplug the power cord prior to installing any devices.
Failure to do so will cause severe damage to the motherboard and components.
Standby
Power LED
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.