DFI CD951-C2600 - Manual (Page 16)

www.dfi .com
16
Chapter 2 Hardware Installation
Chapter 2
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor’s 15-pin D-shell cable
connector to the VGA port . After you plug the monitor’s cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place.
BIOS Setting
Configure VGA in the Chipset menu (“North Bridge Configuration” submenu) of the BIOS. Refer
to chapter 3 for more information.
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.
This jack provides maximum of 60W power and is considered a low power solution. Connect a
DC power cord to this jack. Use a power adapter with 12V DC output voltage. Using a voltage
higher than the recommended one may fail to boot the system or cause damage to the system
board.
VGA
DC-in
DC-in 12V