ETA Bross - Manual (Page 25)

– The manufacturer takes no responsibility for damages and injuries caused by the
incorrect use of supplementary machines and accessories (e.g. ruining of foods, injury,
cuts) and takes no responsibility arising from the warranty on the appliance in the case
that the above safety notices were not followed.
II. FEATURES OF THE DEVICE AND ACCESSORIES (pic. 1)
A – propulsion unit
A1 – ON / Off button A6 – propulsion shaft
A2 – PUlSe button A7 – blender shaft
A3 – revolution regulator A8 – space for storing the supply cord
A4 – safety switch A9 – supply cord
A5 – safety switch A10 – propulsion cover (activates and deactivates the
safety switch)
B – container (activates and deactivates the safety switch)
C – lid
C1 – safety protrusion (activates and deactivates the safety switch)
C2 – feeding opening
D – blender container (activates and deactivates the safety switch)
d1 – rubber seal d3 - lid
d2 - knife d4 – lid plug
E – pusher
F – falcate knife
G – kneading attachment
H – whisking attachment
I – grater two-sides coarse
J – grater two-sided tugging – coarse / fine
K – disc two-sided slicing
L – disc for chips one-sided
M – box
Accessories on figure 7 can be purchased.
III. PREPARATION FOR USE (pic. 2, 3, 4)
Remove all packaging material, remove the blender and accessory. Remove all adhesive
foils, stickers or paper from the appliance. Wash all parts which will come in touch with
food in hot water with soap, rinse them thoroughly with clean water and wipe dry or let dry
before first use. Select the amount of processed ingredients so that the maximum content
of the container does not exceed the mark. It is necessary to divide bigger amounts
of processed ingredients into several portions and check the contents of the container
continuously. We recommend interrupting work occasionally, turning off the appliance and
removing ingredients which have stuck or plugged the accessory or walls of containers,
blender and lid (see par. I. SAFETY PRECAUTION). There is a speed scale depicted
on the housing of the blender. for use of individual attachments follow pic. 6. Times of
preparation (processing) of ingredients are only approximate and depend on amount, type
and quality of substances used and range in seconds to minutes.
Attaching and removing the container (B)
Put the container on the propulsion shaft A6 so that it slides all the way down, arrest it
by turning dextral till a click (the safety switch will release at the same time). Pay special
attention to this operation. Remove the container reversely.
25
GB