ETA Bross - Manual (Page 26)

Attaching and removing the lid (C)
Remove and attach the lid only when the button A1 is in OFF position (the light is off). Put
the lid on the container B so that the protrusion on its edge fits exactly into the protruding
part on the edge of the container. The mark on the lid must be above the handle. Turn the
lid in a direction marked by an arrow till the arrest protrusion C1 clicks into the appliance‘s
safety switch A4. Pay special attention to this operation. The lid is now secured in a
proper position and the propulsion unit A can work. Remove the container reversely.
Feeding opening (C2), pusher (E)
You can add liquids or solid substances through the feeding opening B during operation
of the propulsion unit A. Use the pusher e to push the ingredients in the feeding opening.
Close the filled opening C2 with a pusher.
Attaching and removing the propulsion cover (A10)
Remove and attach the cover only when the button A1 is in OFF position (the light is off).
Put the cover on the propulsion unit A and arrest it with a dextral movement till it clicks
(the safety switch A5 will release at the same time). Pay special attention to this operation.
Remove the container reversely.
Attaching and removing the blender container (D)
Remove and attach the assembled container only when the button A1 is in OFF position
(the light is off). Put the container on the propulsion shaft A7 so that it slides all the way
down, arrest it by turning dextral till it clicks (the safety switch A5 will release at the same
time). Pay special attention to this operation. Remove the container reversely.
Safety switch (A4)
- Prevents the appliance from running if the lid C is not placed on the container B properly.
- Turns off the appliance in case of lid detachment.
Safety switch (A5)
- Prevents the appliance from running if the blender D or the propulsion cover A10 is not
placed properly on the propulsion unit A.
- Turns off the appliance in case of blender detachment.
NOTICE
If the appliance does not work when pressing the ON/OFF button or the PULSE
button but the respective button is lit, it means that the containers or lid are not
placed/closed properly. Check the position/closing of the containers and lid (the
safety switches must be released).
(A1) Button
ON/OFF is intended for grating, stirring, preparing puree and very fine chopping.
(A2) Button
PUlSe, motor runs only for the time it is pressed (max. power). It is intended for cutting
and normal to coarse chopping. Press repeatedly until you achieve desired result.
Revolution regulator (A3)
allows to set optimal revolutions for selected working attachment.
26
GB