ETA Bross - Manual (Page 29)

Blender (D)
Assembling
Remove the cover A10 from a turned-off propulsion unit A. Put the assembled blender
container on the propulsion shaft A7, let it slide down the shaft and turn it clockwise all the
way. Remove the container reversely. do not exert too much pressure on the handle when
attaching or removing the container. for operation of the blender it is necessary to place
the container B (without inserted accessories) on the propulsion unit correctly and secure
the lid C.
Use
The blender is intended for mixing juices, milk shakes, soups, sauces, baby and diet food,
airy dough, sponge cake dough, puree, use button A1 / A2. Regulator setting 2 – max. / —.
Recommendation
- If you process big amounts of food, divide them in separate portions so that you keep
recommended times of operation and rest of the propulsion unit.
- It is better to cut solid ingredients in smaller pieces. do not process very hard ingredients
(e.g. ice-cubes etc.) The knife would become dull very shortly.
- Soak hard ingredients in water before processing (e.g. pulse, soy beans etc.).
- Never remove the cover D3 when the unit is operating.
- liquid ingredients (e.g. oil, milk) or other ingredients may be added to the container after
taking out the plug D4 through the small opening in the lid (when the engine is operating).
We recommend leaving the plug in so that liquid ingredients do not splash out through
the feeding opening.
- The longer you process the ingredients in the blender, the finer the result will be.
- You can also process hot liquids up to temperature of 80 °C, e.g. sauces, soups.
- Never fill the container with liquids which make foam (e.g. milk) up to “MAX” so that they
do not overflow. In this case we recommend amounts approx. 0.5 l.
- If you are not satisfied with the result, turn the appliance off, stir the ingredients using the
spatula, remove part of the ingredients or add some liquid.
- Times of preparation (processing) depend on amount, kind and quality of substances
used, normally they are in tens of seconds.
IV. STORING
Case (M)
for safe and economical storing of all accessory, prevents its blunting and mechanical
damage. There are protrusions on the back panel for hanging the case on the wall. Mind
that there is no electric, telephone or water installation under the plaster in a place of
the holder.
Supply cord (A9)
fold the supply cord into the storing space A8 in the back of the appliance.
V. MAINTENANCE
Unplug the appliance from el. outlet before any handling with the appliance! Do not
use any rough and abrasive cleaning agents! Clean the propulsion unit A with a damp
cloth and soap. Clean all accessories immediately after use in hot water with soap (you
can use a dish washer). You can disassemble the container for easy cleaning (pic. 5).
Be very careful when cleaning the knives and graters!
29
GB