Flowserve MENBLOC 60Hz - Manual (Page 34)

MENBLOC 60Hz USER INSTRUCTIONS ENGLISH 71559945 - 02/13
Page 34 of 36 flowserve.com
8.2 Sectional drawings part list
8.2.1 MENBLOC with an extended motor shaft
ITEM PARTS LIST
1110 Pump casing
1221 Casing cover
2250 Impeller
2540 Thrower
2905 Curved spring washer
3011-01 Radial ball bearing ( Drive end)
3011-02
Radial ball bearing ( Non-drive
end)
3130 Motor end shield
4200
∗
Mechanical seal
∗
4590-01
∗
Gasket
∗
4590-02
∗
Gasket
∗
4590-03
∗
Casing joint
∗
4595 Grommet
6511 Priming plug
6515 Drain plug
6570 Screw
6577-01 Hexagon bolt
6577-02 Hexagon bolt
6590 Washer
6700 Key
8010 Motor
8125 Rotor
8140 Wound stator
8161 Fan
8162 Fan cover
8170 Terminal box
9331 Cover plate
8.3 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be sent
to the Purchaser separately unless the contract
specifically calls for these to be included into the
User Instructions. If required, copies of other
drawings sent separately to the Purchaser should
be obtained from the Purchaser and retained with
these User Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for
retention with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system
etc are provided as separate documents in their
original format. If further copies of these are
required they should be obtained from the supplier
for retention with these User Instructions.
10.2 Change notes
If any changes, agreed with Flowserve, are made to
the product after its supply, a record of the details
should be maintained with these User Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotor dynamic Pumps: a reference
guide, Euro pump Guide No. 1, Euro pump &
World Pumps, Elsevier Science, United Kingdom,
1999.
Reference 2:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom,
1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps -
Nomenclature, Definitions, Application and
Operation.
Reference 5:
ANSI B31.3 - Process Piping.