Guntermann & Drunck UserCenter2/4 - Manual (Page 12)

Guntermann & Drunck GmbH Operating Instructions UserCenter 2 (4)
Page 9
6.6 Darkening of a screen if the hold function is
enabled
With this setting you define whether the screen of a console will be darkened if
another console is active.
To enable darkening proceed as follows:
• Call up the setup mode with CTRL + BACKSPACE
The setup mode will be indicated by the flashing of the three keyboard
LEDs (NUM-Lock, CAPS-Lock, SCROLL-Lock).
• For enabling press V
• To disable the darkening againg press B
After the darkening is enabled/disabled the setup mode will be closed
automatically. The keyboard LEDs stop flashing.
This setting has direct influence on the manual and automatic hold
function (
see chapters 6.4 and 6.5 )
You can always stop the entry by pressing
ESC .
6.7 Transmission of GDFrames
A change of this setting should only be done as agreed with the G&D
service.
For transmitting GDFrames proceed as follows:
• Call up the setup mode with CTRL + BACKSPACE
• For transmission press G
• To disable transmission again press H
After the transmission of GDFrames is enabled/disabled the setup mode will be
closed automatically. The keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC .