Hoist Fitness CL-2412 - Manual (Page 18)

A S S E M B LY
I N S T R U C T I O N S
F R A M E A S S E M B L Y
Step 2g
FITNESS SYSTEMS
R
HOIST
In this step start by attaching (3) to (6) by sliding (34) through the
mount (3), and through (35). Next slide (33) into (6) from the top down
until the locating boss snaps into the location hole. Make sure (35) ends
are pointing down to ensure that (3) locks (4). Attach (12) and (13) to (4)
then slide (4) into (6). Once (4) is in (6) insert (32) to (4). Finally attach
(41), (10) and (40), (11) to (6) as shown. bolts.
Wrench tighten
3 - Latch Assy.
4 - Mid-Chest Chrome Adjuster
6 - Arm Rest Assy.
10 - Right Arm Upholstery Assy.
11 - Left Arm Upholstery Assy.
12 - Mid-Chest Upholstery Assy.
13 - Mid-Chest Upholstery Backing
32 - 1 1/2” x 3 1/2” End Cap
33 - EZ Glide Sleeve
34 - 1.55 x .25 dia. Shaft
35 - Adjuster Spring
40 - Left Hand Upholstery Backing
41 - Right Hand Upholstery Backing
Part Descriptions
H - 5/16-18 x 3 ¾” Hex Head Bolt
J - 5/16-18 x 1 ¼” Button Head Screw
N - Square Head Set Screw
AF - 5/16” Internal Lock Washer
AL - 5/16” Flat Washer
CJ - C-Clip
Hardware Descriptions
2412 Assembly
Page 17