Laminator Direct EZ-LAM Budget PRO - Manual (Page 7)

7
INITIAL SETUP
Unpacking and assembly...
Before unpacking the unit, inspect the shipping container for signs of damage. Notify the carrier
and your dealer immediately if any damage is noted.
Make sure to keep the box and
packaging
The laminator weighs approximately 60 lbs. Use two people when removing the laminator from
the box
Components...
The figure below shows the location of the major components and controls of the EZPRO27. You
should become familiar with these before operating the laminator.
Motor Switch: This three position (FWD/OFF/REV) switch controls power to the Laminating
Rollers. If the switch is pressed to the FWD position the rollers move forward, pulling the plastic
film and laminated material past the rollers.
When this switch is pressed to the REV position the rollers move in the reverse direction. This is
useful clearing wrap-arounds and for clearing film from the rollers. DO NOT RUN THE
ROLLERS IN REVERSE WHEN THERE IS FILM ON THE FRONT ROLLERS.
Heater Switch: This switch turns on power to the top and bottom heated rollers and turns on the
temperature controller.