Lencore Spectra i.Net: Reports User Manual User Manual
Page 11
v1.0
Lencore Acoustics Corp. One Crossways Park Drive West Woodbury, NY 11797 p 516-682-9292 f 516-682-4785 [email protected]
Spectra i.Net®, Spectra® Classic™, n.FORM™, Spectra® Tangent™ are trademarks of Lencore Acoustics Corp. All rights reserved. © Copyright 2013
10
SPECTRA i.NET REPORTS MANUAL
USING i.NET REPORTS FOR AN i.NET SYSTEM INSTALL
If you are at a job site and the system is already installed into the area, first start i.Net Reports and get OP values for
Masking attenuation and contour, as well as paging and music values if the job requires paging and music. If you have
the floor layout you can label OP’s and channels if desired. Otherwise you can assign zones, and/or set sound levels.
These three tasks can be completed in any order.
LABELING OP’S AND CHANNELS
To label different OP’s and channels, get OP values including Zone and OP names/Locations. Then, on the left column
click on the View OP’s tab and expand OP values by clicking the little “plus” icon next to OP Values. This brings up all
the OP’s that you selected during Get OP values.